FM Receiver Breakout Board - AR1010

Product Description

Replacement: BOB-10344. Although not a direct replacement, the Si4703 would be a fitting substitute. This page is for reference only.

Description: This is a breakout board using the AR1010 IC from Airoha. This FM receiver uses a simple command set over an I2C or SPI interface. Connect the OpAmp Breakout and a 3.5mm Audio Jack Breakout to the audio output pins and you will be able to plug in a 3.5mm audio cable to the OpAmp and listen to your favorite FM radio station! Check out the related items below.



Features:

• 
  3.3V @ 11mA


• 
  76-108MHz supported


• 
  100mV audio output


• 
  Stereo output

Documents:

• 
  Schematic


• 
  Example AR1000 ATMega168 Code for reference


• 
  FM Module Datasheet


• 
  AR1010 Datasheet, Programming Guide, and sample C code available upon request


• 
  TEA5767 Datasheet for reference


• 
  Application Note for reference


• 
  Example Project from Cornell

Antenna: An antenna is required. We've used a 31" piece of 22 gauge basic hook up wire with great results.