Product Description
Replacement: KIT-10015. We now build the kit in-house. This page is for reference only.
Description: This kit from Nuxie includes everything needed to build a function generator capable of producing sine, triangle and square waves from 25Hz to over 250kHz. An XR2206 IC is used to generate the various waveforms.
Note: This kit requires a ~14V or higher AC or DC 2.1mm center positive wall wart to fully drive the 12V regulator. Any AC or DC wall-wart that outputs 13V or above should work.
Output Waveforms: 5V TTL Square Wave and selectable Sine or Triangle Wave
Output Amplitude: Square Wave: 5Vp-p, Sine/Triangle: 0Vp-p to approximately 6Vp-p.
Output Frequency: 25Hz to over 250kHz using kit components. Can be modified to 0.01Hz to 1MHz.
The amplitude and frequency adjustment pots are mounted on the board for easy adjustment. An ON/OFF switch, Waveform selector switch and Frequency range switch are also mounted on the board.
Kit Includes:
- FunGen PCB
- XR2206 Function Generator IC
- 74HC04 Hex Inverter IC
- LM741 Op Amp IC
- 2.1mm Centre Positive DC Jack
- 100uF or 10uF Cap
- 5 - 1uF Cap
- 2 - 0.1uF Cap
- 0.22uF Cap
- 2.2nF Cap
- 200Ohm Resistor
- 2 - 1kOhm Resistor
- 3 - 10kIhm Resistor
- 1N4001 Diode
- 3 - Slide Switches
- 2 - 50kOhm Potentiometer
- 1 - 250kOhm Potentiometer
- 7812 Voltage Regulator
- 78L05 Voltage Regulator
- 2x Dual Screw Terminal Connectors
Documents:
USD
United States
Canada